- New
Littelfuse T16A 250 V AC Slow-Blow Ceramic Fuse Ø5 × 20 mm
€0.60
Miniature slow-blow ceramic fuse rated at 16 A and 250 V AC, with a 500 A breaking capacity. Its standard 5 × 20 mm format is suitable for installation in compatible fuse holders.
Security policy
Delivery policy
The Littelfuse T16A Slow-Blow Ceramic Fuse is designed to protect electrical circuits and equipment against overcurrent conditions.
Its time-delay characteristic, identified by the letter T, enables it to withstand short current surges without immediately opening the circuit. This makes it suitable for equipment with high start-up currents, including power supplies, transformers, motors and devices with capacitive or inductive loads.
The ceramic body provides high thermal resistance and helps contain the effects produced when interrupting a high fault current. Its nickel-plated brass end caps provide reliable electrical conductivity and resistance to oxidation.
Measuring 5 × 20 mm, with a 16 A current rating and a maximum voltage of 250 V AC, the fuse must be installed in a holder with the appropriate dimensions and current capacity.
Main features
- Manufacturer: Littelfuse
- Series: 215
- Type: miniature ceramic fuse
- Operating characteristic: slow-blow/time-delay
- Designation: T16A
- Rated current: 16 A
- Maximum rated voltage: 250 V AC
- Breaking capacity: 500 A
- Dimensions: Ø5 × 20 mm
- Opening time at 10 × rated current: 150 ms maximum
- Maximum voltage drop: 200 mV
- Contact material: brass
- Contact plating: nickel
- Operating temperature: −55°C to +125°C
- Soldering temperature: 260°C for a maximum of 5 seconds
- Sale unit: one fuse
Meaning of the T16A marking
- T: slow-blow or time-delay fuse
- 16A: rated current of 16 amperes
- 250 V AC: maximum operating voltage
- 5 × 20 mm: physical fuse size
Recommended applications
- Power supplies
- Transformers
- Amplifiers
- Audio equipment
- Industrial equipment
- Circuits with high start-up currents
- Electrical and electronic systems
- Equipment repair and maintenance
Important note
Always replace the fuse with one having the same dimensions, rated current, voltage, breaking capacity and operating characteristic.
Do not replace a T16A fuse with a fast-acting fuse, a higher current rating or a direct electrical connection. Confirm that the fuse holder, circuit-board tracks and wiring are suitable for a current of 16 A.
A blown fuse must not be repaired or reused. Identify and correct the cause of the overcurrent before installing a replacement.
160160
Data sheet
- Local do artigo na loja
- EL0037
New
7 other products in the same category:
Miniature slow-blow ceramic fuse rated at 16 A and 250 V AC, with a 500 A breaking capacity. Its standard 5 × 20 mm format is suitable for installation in compatible fuse holders.