This pre-assembled coaxial patch cable has a length of 50cm and uses 50Ω RG-58 coaxial cable.

Both ends are fitted with PL male / PL-259 connectors, allowing direct connection between radio communication equipment fitted with compatible SO-239 sockets.

The short 50cm length makes it particularly suitable for interconnections within an amateur radio station, avoiding unnecessarily long cables between equipment installed close together.

It can be used, for example, to connect a transceiver to an SWR meter, antenna tuner, coaxial switch, dummy load or other compatible RF accessory.

The supplier lists a maximum power of 240W.

Main features

Product type: pre-assembled RF coaxial patch cable
Length: 50cm
Cable type: RG-58
Impedance: 50Ω
Connector 1: PL-259 male
Connector 2: PL-259 male
Number of connectors: 2
Listed maximum power: 240W
Main application: interconnection of compatible radio communication equipment and RF accessories

Recommended applications

Transceiver to SWR meter
Transceiver to antenna tuner
SWR meter to antenna tuner
Antenna switches
Dummy loads
Compatible amplifiers within cable limits
CB and amateur radio equipment
RF test benches
Short interconnections using SO-239 sockets

Important note

Before use, always confirm the system impedance, connector type, operating frequency, applied power and required cable-loss performance.

The supplier specifies 50Ω RG-58, PL male connectors and a maximum power of 240W.

Permissible power in a coaxial system can also depend on frequency, connection quality, SWR, temperature and operating conditions. Do not exceed the supplier's specification.

For higher-frequency applications or installations where low attenuation is important, a lower-loss coaxial cable may be preferable.

This item corresponds only to the 50cm RG-58 coaxial patch cable with 2 PL-259 male connectors. Radio equipment, meters, tuners, switches and other accessories are not included.